TinkerKit simplifies electronic prototyping throughout a wide variety of sensors and actuators soldered on orange-coloured boards you can hook up to the Arduino through the Sensor Shield and three-pin cables. A little signal amplifier helps to stabilize the signals running on the cables, ensuring clean analysis from the sensors even on long distances (1m-5m). TinkerKit has been conceived for school teaching and museum exhibitions, allowing the setup of interactive environments on the run, without using soldering iron or breadboard. TinkerKit is the result of years of award-winning experience in Interaction Design. For a long time it has been developed as an internal tool, improved bit by bit project by project, client by client.
Finally the TinkerKit is available.