Arduino Uno Rev3 Mini Bundle

Code: AKX00007
Arduino Uno Rev3 Mini Bundle
$42.50
prices are VAT excluded

The Arduino uno Rev3 mini bundle includes:

  • 1 Arduino UNO Rev3 board
  • 1 USB cable
  • 1 Getting started with Arduino 3rd edition book
  • Overview
  • Tech Specs
  • Documentation
  • Arduino Uno is a microcontroller board based on the ATmega328P (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worring too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

    "Uno" means one in Italian and was chosen to mark the release of Arduino Software (IDE) 1.0. The Uno board and version 1.0 of Arduino Software (IDE) were the reference versions of Arduino, now evolved to newer releases. The Uno board is the first in a series of USB Arduino boards, and the reference model for the Arduino platform; for an extensive list of current, past or outdated boards see the Arduino index of boards.

    You can find here your board warranty informations.

    Getting Started

    You can find in the Getting Started section all the information you need to configure your board, use the Arduino Software (IDE), and start tinker with coding and electronics.

    Need Help?

  • Microcontroller ATmega328P
    Operating Voltage 5V
    Input Voltage (recommended) 7-12V
    Input Voltage (limit) 6-20V
    Digital I/O Pins 14 (of which 6 provide PWM output)
    PWM Digital I/O Pins 6
    Analog Input Pins 6
    DC Current per I/O Pin 20 mA
    DC Current for 3.3V Pin 50 mA
    Flash Memory 32 KB (ATmega328P) of which 0.5 KB used by bootloader
    SRAM 2 KB (ATmega328P)
    EEPROM 1 KB (ATmega328P)
    Clock Speed 16 MHz
    LED_BUILTIN 13
    Length 68.6 mm
    Width 53.4 mm
    Weight 25 g

  • OSH: Schematics

    Arduino Uno is open-source hardware! You can build your own board using the follwing files:

    EAGLE FILES IN .ZIP SCHEMATICS IN .PDF BOARD SIZE IN .DXF

    Programming

    The Arduino Uno can be programmed with the (Arduino Software (IDE)). Select "Arduino/Genuino Uno from the Tools > Board menu (according to the microcontroller on your board). For details, see the reference and tutorials.

    The ATmega328 on the Arduino Uno comes preprogrammed with a bootloader that allows you to upload new code to it without the use of an external hardware programmer. It communicates using the original STK500 protocol (referenceC header files).

    You can also bypass the bootloader and program the microcontroller through the ICSP (In-Circuit Serial Programming) header using Arduino ISP or similar; see these instructions for details.

    The ATmega16U2 (or 8U2 in the rev1 and rev2 boards) firmware source code is available in the Arduino repository. The ATmega16U2/8U2 is loaded with a DFU bootloader, which can be activated by: