Overview
DYNAMIXEL Shield for Arduino MKR allows users to easily use ROBOTIS’ DYNAMIXEL Series along with Arduino MKR Boards.
The features are as follows:
- Compatible with Arduino MKR
- Compatible with ROBOTIS DYNAMIXEL TTL Series (Discontinued DYNAMIXEL may not be supported)
- For 12V DYNAMIXEL power supply, ROBOTIS SMPS 12V 5A PS-10 is recommended
- The included battery connector is compatible with ROBOTIS 3S Li-Po 11.1V batteries LB-010 or LB-020
- Only one JST DYNAMIXEL connector is assembled by default. Please solder included headers when necessary.
- JST DYNAMIXEL connector supports controlling individual servos and daisy-chains.
Parts list:
- DYNAMIXEL MKR Shield (1)
- JST(S3B-EH) (2)
- Molex(5268-02A) (2)
- DC Jack Harness (1)
- Battery Connector(SMW250-02) (1)
- XL-320 Convertible cable (1)
ROBOTIS provides Arduino libraries for DYNAMIXEL Shield to accelerate the development process using Arduino IDE.
Tech specs
| Compatibility | MKR Family |
| VIN(DXL) Voltage¹ | 3.5 ~ 24 [V] |
| Operating Temperature | -10 ~ +80 [°C] |
| Connectors | JST(S3B-EH), Molex(5268-02A) Battery Connector³ (SMW250-02) Terminal Block(DG350-3.5-02P-14) |
| Physical Connection | TTL Multidrop Bus (3.3V Logic, 5V Compatible) |
| Cables | - DC Jack Harness (Type A, O.D.: 5.5 [mm], I.D.: 2.5 [mm]) - Convertible cable for XL-320 |
| Dimensions | 65 x 25 [mm] |
| Weight | 11 [g] |
- ROBOTIS SMPS 12V 5A PS-10 is recommended for 12V DYNAMIXEL power supply.
- Only one JST is assembled by default. Please solder included connectors when necessary.
- The battery connector is compatible with ROBOTIS batteries LB-010 or LB-020.
Documentation
In order to use the AX or MX series TTL cable, solder the included molex connector to an empty DYNAMIXEL Port, or use the Robot Cable-X3P convertible cable.
Please be aware that Arduino MKR boards may limit the 5V power source for USB hardware protection.
More information about the DYNAMIXEL Shield for Arduino MKR Series can be found at the following links below.
Get Inspired
Connect Arduino to a web browser over Bluetooth and see a 3D model and graph moving around - magic!
While it’s yet to make its premiere, Matt Denton has already built the D-O droid from Star Wars: The Rise of Skywalker using a MKR WiFi 1010 for control, along with a MKR IMU Shield and a MKR Motor Carrier. The droid scoots around on what appears to be one large wheel, which conceals the Arduino boards as well as other electronics, batteries, and mechanical components. Denton’s wheel design is a bit more complicated mechanically than it first appears, as its split into a center section, with thin drive wheels on the side that enable differential steering. On top, a cone-shaped head provides sounds and movement, giving the little RC D-O a ton of personality. The droid isn’t quite finished as of the video below, but given how well it works there, the end product should be amazing!
